Pilkington Profilit Hurricane can be filled with Nanogel® aerogel, a new class of lightweight insulation material produced by Cabot Corporation which is ideally suited for daylighting design. The exceptional thermal performance of Nanogel aerogel helps increase energy efficiency. Nanogel aerogel also promotes soft, even light dispersion, reduces unwanted noise and resists condensation. TGP is the exclusive supplier of Nanogel aerogel.
Benefits
| Increases Light Diffusion: |
Eliminates glare, allows soft, even, light dispersion |
| Improves Acoustic Performance: |
Minimizes unwanted noise |
| Exceptional Thermal Performance: |
Reduces heat loss and minimizes solar heat gain |
| UV Stable: |
Maintains performance over time |
| Resists Moisture: |
Prohibits growth of mold, mildew and fungus |
| Provides Green Solutions: |
Reduces building design loads and conserves energy |
| Adheres to Guidelines: |
Meets and exceeds strict building codes |


Standard Cast
Patterned surface with a slight green hue

Amethyst
Standard Cast with a blue coating

Antisol®
Standard Cast with a bronze hued performance coating to control solar heat gain

Clear
No pattern or hue

Micro Cast
Muted fine mesh texture with slight green cast
(Click on image to see close-up
representation of glass texture)

Opaque
Opaque polycarbonate laminate decreases translucency
Pilkington Profilit Hurricane should be installed in accordance with approved shop drawings – plumb, level, square and free from warp or twist while maintaining dimensional tolerances and alignment with surrounding construction.
Erect framing, vinyl spacer and glass in accordance with manufacturer’s printed installation instructions. Seal glass units continuously on both sides of glass between frame and glass and between linear glass units. Install perimeter joint sealant and backing materials between assemblies and adjacent construction.
Pilkington Profilit Hurricane has been tested to meet the following standards: Miami/Dade County, NOA number 06-0810.12, TAS 201, TAS 202, TAS 203, Florida State Product approval # FL 10792, AAMA 501.4, AAMA 101, AAMA 1801-97, AAMA/NWWDA 101/1, S.297, ASTM F 588-97, NFRC 100-97, ANSIZ97.1-1984, CPSC 16CFR 1201, Category II. All testing carried out by Architectural Testing Inc., York, PA.; Fenestration Testing Labs, Medley, FL; and ETC Labs, Rochester, NY. Formal test results are available by contacting Technical Glass Products.
Note: Exceptions to hurricane rating approval include horizontally glazed orientation, radius, serpentine and all glass corner configurations.
Please see our complete 3-part CSI format Profilit specifications.
Technical Glass Products can also offer project specific assistance upon request.
To obtain CAD details for this product, please use our CAD request form.